Gym acceleration load depends on sensor placement
In short
Gym acceleration load depends on sensor placement: all metrics were higher at the ankles than the back in 10 youth tennis players. Compare matching sites and metrics; record lifted kilograms and reps separately from accelerometry.
A larger acceleration load at the ankle does not mean an athlete lifted more kilograms than a sensor on the back recorded. In a study of 10 high-performance youth tennis players, every accelerometry metric was higher at the ankles than at the thoracic or lumbar sites (p<0.05). That makes placement part of the measurement itself. A leaderboard that mixes ankle and back readings could rank differences in measurement conditions as if they were differences in training.
Which sessions and sensor locations were compared?
The athletes completed two identical plyometric sessions and one resistance-training session. They wore inertial measurement units, or IMUs, at the thoracic spine, lumbar spine, left ankle and right ankle. The analysis included peak upward acceleration (PUpAcc), one-dimensional upward PlayerLoad (1DPL-up), two-dimensional PlayerLoad and three-dimensional PlayerLoad. These are accelerometry-derived descriptions of the session, rather than a measurement of the external weight on a barbell.
| Comparison | Observation | Interpretation |
|---|---|---|
| Ankles versus back sites | All metrics higher at the ankles | Do not treat different sites as interchangeable |
| Plyometric versus resistance session | All thoracic metrics distinguished the session types | Session discrimination does not establish superior training effects |
| Repeated plyometric sessions | Thoracic PUpAcc ICC 0.53 | Moderate between-session reliability |
Does a fixed location make every change trustworthy?
A consistent site is a starting point, but the reliability results still limit interpretation. At the thoracic site, 1DPL-up had poor between-session reliability, with an intraclass correlation coefficient of 0.49. PUpAcc was moderately reliable, with an ICC of 0.53. An ICC of 0.53 does not mean 53% accuracy. It describes reliability under the study conditions; it does not establish a percentage error against a known true load. The reported limited agreement between sensors for PUpAcc adds another reason to avoid treating a small change as proof of improved strength.
What should go into a lifting log?
- Record the actual kilograms lifted, repetitions and sets for the exercise.
- Attach the anatomical sensor site and the metric name to any acceleration value.
- Check that site, metric and session conditions match before interpreting a change.
For fairlift, the practical distinction is between the lifting record and the sensor note. Keep actual weight and repetitions as the description of what was lifted. A PlayerLoad value can sit in a separate note with its measurement context, but this study provides no conversion from that value to a 1RM or Muscle Index score. Likewise, the ability of thoracic metrics to distinguish plyometric and resistance sessions does not show that either session builds more strength or muscle. A sensitive session descriptor and a demonstrated training benefit answer different questions. Read about wearable calorie estimates, and use the Muscle Index calculator for completed lifts.
This was a small study in youth tennis players using IMUs at the back and ankles. Consumer wrist watches were not tested. The findings do not establish wrist-device accuracy, results for all adult lifters, or the long-term superiority of either training method.
Frequently asked questions
Can ankle and back acceleration loads be compared directly?
They should not be treated as interchangeable. All measured metrics were higher at the ankles than the thoracic or lumbar sites in 10 youth tennis players, so the anatomical site must stay attached to the value.
Does a higher PlayerLoad mean more kilograms were lifted?
No. These metrics describe accelerometry and do not replace lifted kilograms or a 1RM. Keep actual weight and repetitions as separate training records.
Can this study judge wrist watches or show that plyometrics are better?
The study did not test wrist watches or compare long-term training adaptations. Thoracic metrics distinguishing session types cannot establish general device accuracy or the superiority of one training method.
Source: PubMed (published )